Windows could not update the computer's boot configuration
If while upgrading Windows 11/10/8/7 to a newer version, you receive Windows could not update the figurer's boot configuration, Installation cannot proceed fault, then this mail may be able to help yous.
Windows could not update the computer's boot configuration, Installation cannot proceed
One ascertainment is that this result is more specific to computers using the Intel 82801ER chipset co-ordinate to Microsoft. Though nosotros must say that it could happen with any estimator if the Kick configuration files were corrupted. If you receive this mistake bulletin while upgrading your Windows computer, here are a few things you could try.
i] Disable UEFI in Kick Options
UEFI is the acronym for Unified Extensible Firmware Interface. It is basically a replacement for BIOS which is used to ready the hardware and load and start an operating system in today'south Windows 10/8 PCs.
Check if your PC uses UEFI or BIOS. If it uses UEFI, access UEFI Firmware settings and disable it in the BIOS and see. You will see the setting under Kick Order card', Disable UEFI or EFI sources or something like that.
If you wish, you may use EasyUEFI, which is a costless software that helps in managing the EFI/UEFI kicking options in Windows.
If your computer uses BIOS, update your BIOS and see if information technology helps you.
ii] Repair MBR
If the above does non assistance, you may accept to rebuild the Kicking Configuration files. To rebuild or repair the Chief Kicking Record, you need to utilise the Bootrec.exe tool.
Open the Settings page, click on Update and Security and so amongst the links on the left-paw side, select the Recovery tab. Click on Restart at present nether Advanced Setup and wait for your reckoner to boot in Advanced Startup Options mode.
In the Advanced Startup options menu, select the pick for Command P rompt and run the following commands:
bootrec /RebuildBcd bootrec /fixMbr
bootrec /fixboot
Leave and now reboot the organization and try upgrading the operating organization once once again.
There is another suggestion existence mentioned on the Internet, which has worked for some, although I cannot be sure of this. The suggestion is to connect the Hard Drive to another computer, perform a Clean command using diskpart, and then go to Disk Management right-click on the disk and select Initialize disk. Next, choose GPT. Having done this, endeavour to put the Hard Drive back into the original calculator and install windows and meet if information technology helps you.
Hope something helps!
Related read: Windows setup could not configure Windows to run on this computer's hardware.
Source: https://www.thewindowsclub.com/windows-could-not-update-computers-boot-configuration
Posted by: martinezbealad.blogspot.com
0 Response to "Windows could not update the computer's boot configuration"
Post a Comment